Are you ready to transform your car? Browse our selection of high-quality vinyl wraps and find the perfect match for your vehicle. If you need assistance, our team is here to help you choose the right wrap and provide tips for a successful application.
Don’t wait any longer—let’s make your car stand out on the road! Get Started Today!
Car Vinyl Wrap Tips
1,Make sure you have all the tools you need before starting the installation process as below, Squeegee , Towel, Gloves, Heat Gun, Car Wrap Magnet, Wax, Knifeless Cut Tape (basic tools as below)
2. Install the wrap in a clean, sheltered space: Keeping your car's surface clean while installing a wrap can be an uphill battle if you're working in the open air or a dirty garage. It takes several days to install a complete wrap, so find a clean, sheltered space where it's easy to keep the surface free from debris.
3 Ensure the surface is perfectly smooth and clean: Be sure to give your vehicle a thorough clean and polish before installing the wrap.The possible places are corners, bottom edges, handles, under the front and rear bumpers, including the dead corner of the upper guard plate of the hub. The air compressor blows away the dirt and sewage remaining in the gaps of the corners to avoid the situation that the film will not be stuck and will cause the edge to be raised later.
4 When the car body have scratches or uneven, it needs to solve this problems firstly. you can wax it firstly to avoid too sticky,but no edge part. If there are any uneven parts, fill them with putty.
5 Make sure the substrate is completely dry before applying the film. If necessary, use a blow dryer or heat gun to speed up.
6 It is better to wrap a complete vinyl to one part of car body,reduce splicing.Correct direction of closing vinyl edge is from outside to inside.
7 After the film is finished, all the corners should be baked with a hot air gun at high temperature. While baking, compact the shape by hand until the baking heat no longer starts. For the parts that are easy to be edged or the glue does not stick to the edge that has been edged, it can be appropriately reinforced with adhesion promoter or super energy glue.
8 After the color change is completed, it needs be careful care in a short period of time. Do not wash the car within 3 days. and it cannot be directly sprayed at the seam between the film and the car paint with a high-pressure water gun; it cannot be pasted with items such as adhesives To the membrane surface, and can not use a brush, abrasive or sponge with abrasive to clean the membrane surface.
9 if possible， wrap your car on dry, warm days: Cold weather makes the vinyl stiff and more prone to cracking as you stretch it across your car, while increased humidity prolongs the curing process.
Steps
- Check thecar surface make sure paint condition is good
- Wash the car and blow dry
- Measure and Cut the film，Stick it on car body
- Applyingthe wrap,Use squeegee to wrap and get bubble out
- Do well with edges,Using a heat gun to stretch and mold the vinyl wrap
- Done Wrap work