TPU Glossy Rose Latte Pink Colored PPF Paint Protection Film

ALUKO Paint Protection Film

ALUKO Paint Protection Film (PPF) is a high-performance, urethane film which includes clear PPF and colored PPF . It designed to shield your vehicle's paint from scratches, rock chips, UV rays, and other environmental damage. 

Installation Conditions and Guidelines

Installation Environment:

Room Temperature: 25 ± 3°C
Humidity: 50 ± 5% RH
Cleanliness: Clean, dust-free, and free of visible suspended particles

Recommended Tools:

Rubber scraper, buffer, masking tape, heat gun, magnet, gloves, IRR thermometer, spray, towel, and installation fluid.

Application: Standard method for paint protection film. Avoid excessive stretching or heating. Post-heating may be required. Post-heating temperature: 110°C for flat surfaces, 130°C for curved surfaces and overlapping areas.
Post-care: pH neutral. Avoid the use of waxes or solvents.

Installation Instructions:

✅ Pre Installation Tips

• Surface Preparation is Critical , Wash the vehicle thoroughly to remove dirt, wax, and grease.

• Work in a Controlled Environment,  Install in a dust-free, well-lit area

• Use High-Quality Installation Tools , A squeegee with a felt edge, heat gun, and precision knife are essential.  Avoid sharp or metal tools that could scratch the film.

✅  During Installation Tips

• Stretch & Position Carefully. Aluko’s PPF is highly conformable, but use a heat gun (low-medium heat) to soften the film for complex curves. Overstretching can thin the film—gentle tension is key.

• Squeegee from the Center Outward, Start in the middle and push air/water toward the edges to prevent trapped bubbles. Apply firm, even pressure to ensure full adhesion.

• Trim Excess Film Before Final Drying.Use a fresh, sharp blade for clean cuts.  Leave a small margin (1-2mm) near edges to avoid peeling.

✅  Care Tips

• Allow Proper Curing Time . Avoid washing or heavy rain for at least 24-48 hours to let the adhesive fully bond.

• Avoid Harsh Chemicals & Automatic Car Washes . For the first 2 weeks, hand wash only with pH-neutral car shampoo.  Avoid strong solvents, waxes, or silicone-based products—they can damage the film’s hydrophobic layer.

• Use Heat to Reactivate Self-Healing Properties  If minor scratches appear, park in sunlight or use warm water to activate the self-repairing top coat.

• Regular Maintenance for LongevityUse a PPF-safe detailer spray to maintain gloss and prevent contaminants from bonding. Inspect edges periodically to ensure no lifting occurs.